The Whirlpool WPW10381562 Door Boot Seal provides the washing machine with a tight and secure door seal which prevents leaks and enhances its operational performance. The door boot seal functions as a water-tight barrier that connects the drum to the door to stop water leakage during washing cycles. This component functions through its flexible and durable design which preserves proper pressure inside the washer.
Please, mind that only logged in users can submit questions
Installation Steps
Step 1: The Whirlpool washer is disconnected from the electrical outlet and the water supply is turned off.
Step 2: The washer’s front panel is taken off. To accomplish this, the fasteners located at the top and bottom of the front panel are unscrewed. After the screws are taken out, the panel is elevated to detach it from the frame and placed aside.
Step 3: The bellow is detached from the washer by taking off the clamps that secure the bellow in position.
Step 4: A putty knife is utilized to scrape away any leftover residue or debris on the washer’s frame surface.
Step 5: The new bellow is positioned to replace the old one by tightening the clamps firmly.
Step 6: The front panel that was taken off in step two is reinstalled, ensuring all screws are fastened in their designated spots.
Step 7: The washer is reconnected to the electrical outlet, and the water supply is activated.
Step 8: A cycle is executed to verify that the bellow is operating properly.
Please remember, these instructions are served as general guidance and should always be used alongside the manufacturer's manual, if one is available.
