The store will not work correctly in the case when cookies are disabled.
We collect user information to provide a better user experience and protect the security of our website. By continuing to use our website, you acknowledge the use of cookies.
The General Electric WH01X24381 Washer Lid Lock Bezel controls the component actuator as the appliance closes, maintaining the locking mechanism aligned with the strike point and controlling the latch system during cycle start. It is installed on the top control area of washers, surrounding the lid lock opening within the console panel where the bezel fits into the molded cutout. It supports the movement and seating of the lock assembly by maintaining the correct position between the lid strike and locking tab, allowing the mechanism to transition between locked and unlocked states during operation cycles.
Step 1: The dryer is disconnected from the electrical outlet and the top panel of your dryer is taken off.
Step 2: The lid lock assembly is identified and the two wiring connectors are detached from it.
Step 3: The screws securing the lid lock bezel are extracted, then they are gently taken off the assembly.
Step 4: The new WH01X24381 GE Lid Lock Bezel is obtained and placed into the lid lock assembly, ensuring correct alignment.
Step 5: The bezel is fastened using the screws.
Step 6: The two wiring connectors are reattached to the assembly.
Step 7: The dryer's top panel is reinstalled and it is reconnected to the electrical outlet.
It is important to note that these instructions are served as general guidance and should always be used alongside the manufacturer's manual, if available.
