The General Electric WD19X25278 Dishwasher Diverter Valve Assembly Kit plays the role of regulating the water flow and its distribution in the dishwasher. It works during the wash cycle and controls the flow of water to the various spray arms to increase the efficiency of washing.This kit is essential in regulating the water pressure and enhancing the efficiency of the washing process to produce better result. Replacing a diverter valve that has gone bad ensures that there are no leak and that the dishwasher will run efficiently without the need for repair.
Step 1: The dishwasher is disconnected from the electrical outlet and the water supply is shut off.
Step 2: The door of the dishwasher is opened and the racks are taken out to reveal the bottom section of the appliance.
Step 3: The diverter assembly kit situated at the bottom of the dishwasher is identified and a screwdriver is employed to take out the two screws securing the assembly.
Step 4: The old diverter assembly is gently extracted and the electrical Wiring linked to it is disconnected.
Step 5: The new diverter assembly is grasped and the electrical Wiring is connected to its terminals.
Step 6: The new assembly is positioned and a screwdriver is utilized to fasten it with the two mounting screws.
Step 7: The dishwasher door is shut and the appliance is reconnected to the power supply and the water source.
Step 8: A test cycle is initiated to verify that the new assembly operates correctly.
Remember, these instructions are served as general guidance and should always be followed alongside the manufacturer's manual, if one is accessible.
