The Samsung DC97-18247A Washer Outer Rear Tub Assembly firmly holds the drum and ensures that it rotates smoothly, and evenly. It covers the spin basket, minimizes vibration and helps keep the machine in proper alignment during the wash, and spin cycles.
Step 1: The power supply to your Samsung DC97-18247A ASSY S.TUB BACK should be disconnected. The power source should be ensured turned off prior to commencing any repairs.
Step 2: The panel on your appliance should be accessed. This panel can be found at the back or side of your Samsung DC97-18247A ASSY S.TUB BACK.
Step 3: The screws and bolts that are holding the old assembly in place on the appliance should be removed.
Step 4: The old assembly should be extracted and disposed of.
Step 5: Your new Samsung DC97-18247A ASSY S.TUB BACK should be taken and carefully positioned in the same location from which the old assembly was taken.
Step 6: The new assembly should be fastened using the screws and bolts that were removed from the old one. They should be ensured tightened adequately, but not over-tightened.
Step 7: It should be verified that the new assembly is properly installed and functioning as intended.
Step 8: Once satisfied, the access panel should be closed.
Step 9: Your work should be reviewed and the appliance should be reconnected to its power supply.
Congratulations! Your Samsung DC97-18247A ASSY S.TUB BACK has been successfully replaced.
Be aware that these instructions are served as general guidance and should always be followed in conjunction with the manufacturer's manual, when available.
