The Samsung DE81-07046A Range Hot Surface Igniter Assembly operates by heating electrically to ignite the gas to operate the burner. When it is turned on, it heats to the necessary temperature, and the gas lights up to form a continuous flame. This is installed into the range burner system, and it is placed in such a way that it can be ignited properly during cooking cycles. It offers a safe sparkless way of igniting the flame to maintain a steady heat within the appliance.
Step 1: The range should be disconnected from the electrical outlet.
Step 2: The rear panel of your range should be detached by unscrewing the screws securing it. All screws should be kept organized, as they will be needed to reinstall the rear panel after the task is completed.
Step 3: The existing hot surface igniter should be identified and detached from the wiring harness. The needle nose pliers should be utilized to carefully extract the wires.
Step 4: The new hot surface igniter should be taken, the wiring harness should be attached, and it should be fastened into position using the provided hardware.
Step 5: Next, the connections of the new hot surface igniter should be verified with a multimeter. If all connections are satisfactory, the rear panel of the range should be reattached and it should be reconnected to the electrical outlet.
Step 6: The range should be powered on and it should be confirmed that the new hot surface igniter is functioning correctly.
Please remember that these instructions are intended for general guidance and should always be utilized alongside the manufacturer's manual, if available.
