Step 1: The power source to the washer is disconnected and the plug is removed.
Step 2: The agitator shaft, situated at the center of the tub, at the bottom of the agitator, is identified.
Step 3: The two screws securing the agitator shift actuator coupling are taken out.
Step 4: The agitator shift actuator coupling is detached from the agitator shaft.
Step 5: The new agitator shift actuator coupling is installed in place of the old one.
Step 6: The new agitator shift actuator coupling is fastened using the two screws.
Step 7: The power source is reconnected and the washer is activated.
Step 8: It is confirmed that the agitator shift actuator coupling is functioning correctly by executing a cycle.
It is important to remember that these instructions serve as general guidance and should always be utilized alongside the manufacturer's manual when available.
