Step 1: The LG Washer is disconnected from the power source.
Step 2: The back panel of the washer is taken off. The entry point is typically located at the bottom right-hand corner of the appliance.
Step 3: The bearing is identified. The MAP61913714 LG Washer Tub Ball Bearing will be positioned directly behind the motor at the upper section of the tub.
Step 4: The screw is extracted from the bearing, then the bearing is removed from the washer.
Step 5: The new bearing is placed and fastened securely with the screw.
Step 6: The back panel is reattached to the washer.
Step 7: The washer is reconnected to the power, it is switched on, and a cycle is run to verify that the bearing functions properly.
It is important to remember that these instructions are served as general guidance and should always be used alongside the manufacturer's manual, if one is available.
