Toggle Nav
Search
  • 0 My Cart
Toggle Nav
main product photo

General Electric WE11X27519 Dryer Heater Assembly

Be the first to review this product
Special Price $97.94 Regular Price $158.74
In stock
Available Quantity:   10
SKU
WE11X27519

Product Description

The General Electric WE11X27519 Dryer Heater Assembly provides the heat needed per drying cycle heating the air flowing through the drum. Its primary function is to increase the temperature within it to enable moisture to evaporate efficiently. This mechanism uses an electric heating coil which is activated when it is energized providing a continuous supply of heat as air passes over it. It is installed in the heating compartment, and it is mounted by attaching the assembly and hooking up the electrical connections.
Add to Wish List
Dryer Parts, View All Parts,
Manufacturer
https://www.hnkparts.com/media/catalog/product/w/e/we11x27519.jpg

This Part Fits the Following Models (2)

Write Your Own Review
You're reviewing:General Electric WE11X27519 Dryer Heater Assembly
Your Rating
FAQS
Customer Questions
What maintenance is required for the General Electric WE11X27519 Heater Assembly?

Ensure the heater connections are tight and free from dust accumulation. Confirm the assembly heats evenly during operation. Keep airflow channels clear to prevent overheating. Verify the electrical supply is stable before each use for consistent drying performance.

What are common issues with the General Electric WE11X27519 Heater Assembly?

  • Dryer not producing heat.
  • Clothes drying slowly.
  • Cycles ending before clothes are dry.
  • Inconsistent temperature during operation.

Installation Steps

Step1: Turn off the power supply at the breaker panel to prevent electrical shocks.

Step2: Remove the rear service panel to reach the heating section inside.

Step3: Disconnect wire leads attached to the existing heater carefully.

Step4: Unscrew mounting hardware and slide out the worn heater assembly.

Step5: Insert replacement heater into position and secure with screws.

Step6: Reattach wiring, reinstall panel, restore power, and run a heat test.