Toggle Nav
Search
  • 0 My Cart
Toggle Nav
main product photo

General Electric WD05X32018 Dishwasher Dry Boost Heater & Blower

Rating:
5 5 1
1 Review Add Your Review
Special Price $79.97 Regular Price $129.63
In stock
Available Quantity:   33
SKU
WD05X32018

Product Description

The General Electric WD05X32018 Dishwasher Dry Boost Heater and Blower supports the drying process by using the hot air and directing it to the interior surfaces of the appliance. It has an in-built heating unit, and a fan to circulate warm air inside the tub after the wash cycle has been finished. It is installed in the interior drying compartment and is networked to wiring, ducts, and mounting provisions, assisting in controlling airflow. Its purpose aids effective moisture extraction and the heated air circulates throughout the drying process.
Add to Wish List
Dishwasher Parts, View All Parts,
Manufacturer
✓ This Product Replaces: WD05X25648
https://www.hnkparts.com/media/catalog/product/w/d/wd05x32018.jpg

This Part Fits the Following Models (40)

Showing 1-15 of 40
Write Your Own Review
You're reviewing:General Electric WD05X32018 Dishwasher Dry Boost Heater & Blower
Your Rating
FAQS
Customer Questions
What maintenance is required for the General Electric WD05X32018 Dry Boost Heater & Blower?

Inspect the assembly periodically to ensure unobstructed airflow and proper heating performance. Remove debris that may restrict ventilation. Verify secure electrical connections. Monitor drying results to confirm consistent heat distribution and efficient moisture removal.

What are common issues with the General Electric WD05X32018 Dry Boost Heater & Blower?

  • Dishes remaining wet after cycles.
  • Heater not producing sufficient heat.
  • Blower failing to circulate air.
  • Extended drying times occurring.

Installation Steps

Step1: Disconnect the dishwasher from the power supply before servicing.

Step2: Remove the lower access panel to reach the heater and blower assembly.

Step3: Disconnect wiring and mounting screws from old unit.

Step4: Carefully remove the old heater and blower assembly.

Step5: Install new unit and reconnect all electrical connectors.

Step6: Reassemble panel and run drying cycle to verify performance.