The Samsung DA82-02869A Water Filter Case works by containing the filter in the refrigerator water system and purifying water through it. The case is made in such a way that it will not allow any water to seep through and will allow a constant flow of water. When the filter is placed in right position, it increases the rate of filtration and the quality of the water and ice produced. This filter case enhances the durability of the filter and enhances the efficiency of the appliance and the quality of water.
Please, mind that only logged in users can submit questions
Installation Steps
Step 1: Your Samsung refrigerator should be disconnected from the electrical outlet.
Step 2: The DA82-02869A Samsung Refrigerator Water Filter Case Assembly should be found. Typically, this is situated on the lower left section of the refrigerator.
Step 3: The grille should be lifted and the filter housing identified. The two screws securing the base of the filter housing should be taken out.
Step 4: The housing should be extracted from the grille and rotated to the side for removal.
Step 5: The cap should be unscrewed from the water filter assembly and the old filter removed.
Step 6: The new water filter should be placed into the housing and the cap reattached onto the assembly.
Step 7: The housing should be reinserted back into the grille and the two screws at the base of the housing fastened.
Step 8: The power cord should be plugged back into the refrigerator and it reconnected.
Step 9: Cold water should be dispensed through the fresh water dispenser for one minute to activate the new filter.
Step 10: The old filter should be disposed of and the taste of filtered water provided by your new DA82-02869A Samsung Refrigerator Water Filter Case Assembly should be savored!
It is important to note that these directions should be utilized as general guidance and always be utilized alongside the manufacturer's manual, if accessible.
