The Avanti Products AS35U6 Compressor is located in small fridges, where it plays the primary role of ensuring that the fridge is kept at cooling temperatures. The unit pressurizes refrigerant gas and runs it through the refrigeration cycle to remove heat from the inside of the appliance. It operates through the low-pressure refrigerant in the evaporator and compressing it to a high-pressure level and then to the condenser to dissipate heat.
Step 1: The refrigerator should be disconnected from the power source and ensured to be fully turned off, then all food items inside should be taken out.
Step 2: The rear panel of the refrigerator should be taken off to access the compressor.
Step 3: The compressor should be detached by removing screws and the electrical wires linked to it should be disconnected.
Step 4: The power capacitor, suction line, and discharge lines should be unlinked from the compressor.
Step 5: The new compressor should be positioned by attaching the power capacitor, suction line, and discharge lines to it.
Step 6: The new compressor should be fastened to the back of the refrigerator using screws.
Step 7: The electrical wires should be reconnected to the new compressor.
Step 8: The rear panel of the refrigerator should be reattached.
Step 9: The refrigerator should be switched on and inspected for any leaks.
Step 10: The refrigerator should be refilled with food and your newly installed compressor should be enjoyed.
Please remember that these guidelines are served as general advice and should always be utilized alongside the manufacturer's manual, if one is accessible.
