The LG 5859EA1004G Washer Drain Pump Assembly unloads the appliance after every cycle to drain the wastewater. It can be installed in LG-compatible washers where the water is pumped out via the drain hose to avoid the standing water in the drum. Keeping the water flowing efficiently and minimizing chances of blockages or leakages helps in safeguarding the appliance, facilitates better washing performance, and ensures that the appliance works efficiently.
Step 1: The power supply is disabled. Either the washer is unplugged or the breaker in the main circuit panel that provides electricity to it is switched off.
Step 2: The fill and drain hoses linked to the water pump are detached. Any hose clamps that may be securing them are removed.
Step 3: The bottom access panel is removed. It is attached with screws, which need to be taken out prior to accessing the pump.
Step 4: The two mounting bolts that hold the pump in position are unscrewed. Two are located on the top of the pump and one on the side.
Step 5: The pump is extracted from the washer. If removal is resisted, additional screws or nuts may be securing it.
Step 6: The wire harness is disconnected from the motor.
Step 7: The new drain pump is positioned. It is fastened with the mounting screws.
Step 8: The wire harness is reconnected to the new motor.
Step 9: The fill and drain hoses are reattached. They are ensured secured firmly using hose clamps.
Step 10: The access panel is placed back in position.
Step 11: Power is restored by plugging the washer back in or turning the circuit breaker on.
Step 12: The washer's functionality is verified by running a cycle. If it operates correctly, the 5859EA1004G LG Washer Water Drain Pump Assembly has been successfully replaced.
Please note that these instructions are served as general guidance and should always be utilized alongside the manufacturer's manual, if accessible.
