Speed Queen 203935 Washer SPST Normally Open Push Button Switch-Black

Step 1: Begin by disconnecting your 203935 Speed Queen Washer from the power source and detaching any water lines that are attached to it.

Step 2: The push button switch situated on the control panel should be identified, then the screws that hold it securely should be taken out. These screws should be set aside for future use.

Step 3: With a flathead screwdriver, the old push button switch should be gently levered away from the control panel.

Step 4: The new push button switch should be examined for any signs of damage or defects. If it looks to be in proper condition, the next step should be moved on to.

Step 5: The two electrical wires that were connected to the previous push button switch should be carefully guided through the opening in the new switch.

Step 6: The new push button switch should be fastened using the screws that were previously removed. It should ensure that the screws are secure, but overtightening should be refrained from.

Step 7: Your 203935 Speed Queen Washer should be reconnected to the power source and any water lines that were previously disconnected should be reattached.

Step 8: The washer should be activated and it should be verified that the push button switch operates correctly by pressing the start button. If functioning properly, the cycle should commence.

Following these procedures will guarantee that your 203935 Speed Queen Washer Push Button Switch is replaced accurately and safely. Caution should be exercised during the replacement of the push button switch to enhance the performance of your washer.

Please remember, these instructions serve as general guidance and should always be utilized alongside the manufacturer's manual, if available.