The Speed Queen 202937 Washer Pressure Switch 10.0 Max keeps track of the water level by measuring air pressure inside the wash tub. This switch sits within the control system of the washer, connecting to the air dome hose and wiring harness to send a signal to the main control. The switch activates when it sees a change in pressure indicating the proper fill level has been reached.
Step 1: The power supply should be detached from the washer and the water supply should be turned off to the unit.
Step 2: The pressure switch located at the rear of the washer should be found. It is secured with two small Philips head screws.
Step 3: The screws should be extracted and the pressure switch should be gently taken out from the back of the washer.
Step 4: The arrangement of the wires connected to the pressure switch should be observed. This will assist in reconnecting it accurately later.
Step 5: The new pressure switch should be positioned by attaching the wires in their original locations, then the two screws should be tightened to fasten it securely.
Step 6: The power supply and water inlet should be reattached to the washer.
Step 7: The washer's operation should be verified by running it through a cycle to ensure that the pressure switch is performing properly.
Adhering to these straightforward steps will guarantee a successful installation of your 202937 Speed Queen washer pressure switch. Caution should be exercised when handling electrical components, as even a minor error could lead to significant harm.
Please remember, these instructions should be utilized as general guidance and should always be utilized alongside the manufacturer's manual, if accessible.
