The Frigidaire 111920868 Dishwasher Spray Arm serves the function of spraying pressurized water all over the machine to clean the surfaces. It primarily works by rotating and spraying water in various directions, cleaning dishes, and utensils of food particles. The spray arm is attached to the water supply and turns with jets of water going through the nozzles. It is installed by snapping or clamping to the spray arm support or hub. This part assists in facilitating complete cleaning efficiency, even water coverage and overall washing functionality improvement in each cycle.
Step 1: The dishwasher should be disconnected from the electrical outlet and the water supply should be turned off.
Step 2: The dishwasher door should be opened and the lower rack should be taken out.
Step 3: The spray arm positioned at the base of the dishwasher should be found and the Phillips head screwdriver should be utilized to take out the screws holding it in place.
Step 4: After the screws have been taken out, the spray arm should detach without difficulty.
Step 5: A rag or cloth should be used to wipe down the area where the spray arm was attached.
Step 6: The replacement spray arm should be taken and aligned in the same manner as the previous one.
Step 7: The new spray arm should be fastened with the screws that were removed previously.
Step 8: The lower rack should be put back into the dishwasher and the door should be shut.
Step 9: The water supply should be restored and the dishwasher should be reconnected to the wall outlet.
Step 10: A cycle should be executed to confirm that the new spray arm is functioning correctly.
Please remember, these guidelines serve as general advice and should always be followed alongside the manufacturer's manual, if accessible.
