The Bosch 11019240 Dishwasher-Operating Module operates by sending programmed functions that guide the cycles and functions of the appliance. The module transmits the chosen setting to execute it correctly. It is a part of the internal electronic system, located in the control section of the dishwasher.
Step 1: The power cable is disconnected from the rear of the appliance.
Step 2: The two Phillips head screws that hold the top cover in place are taken out.
Step 3: The top cover is gently raised off the appliance to reveal the internal components.
Step 4: The cables connected to the Operating Module Prog are detached.
Step 5: The four Torx head screws securing it are removed and the Operating Module Prog is taken off its support bracket.
Step 6: The new Operating Module Prog is positioned onto the support bracket.
Step 7: It is fastened using the four Torx head screws.
Step 8: The cables are reconnected to the new Operating Module Prog.
Step 9: The top cover is replaced and fastened with the two Phillips head screws.
Step 10: The power cable is reconnected to the back of the appliance.
Well done, your Bosch 11019240 Operating Module Prog has been successfully replaced!
Please note that these instructions are served as general guidance and should always be referenced alongside the manufacturer’s manual, if available.
